Jun 23, 2009 · The output from that command shows a successful trace: traceroute to msu.edu (35.8.10.134), 30 hops max, Traceroute performs each hop three times.
If the issue is that traceroute goes more than 30 hops to reach the destination and does not complete, then the best solution is to use extended trace (from privilege mode) and set the maximum number of hops to a larger value like this: Oct 16, 2017 · Prevents tracert from attempting to resolve the IP addresses of intermediate routers to their names. This can speed up the display of tracert results. /h
It start its probes with a ttl of one and increases this by one until it gets an ICMP "port unreachable" (or TCP reset), which means we got to the "host", or hit a max (which defaults to 30 hops). Three probes (by default) are sent at each ttl setting and a line is printed showing the ttl, address of the gateway and round trip time of each probe.
Traceroute limitations are well known and should be taken into account when using the tool. For example, traceroute does not discover paths at the router level, but at the interface level. Another limitation appears when routers do not respond to probes or when routers have a limit for ICMP responses. Specify Max_TTL / Maximum Hops. Sets the maximum number of hops in which the packet should reach the destination. The default value is set to 30. cherisim@putor ~]$ traceroute -m [max_ttl] google.com Specify Gateway to Use. Specifies the gate through which traceroute will route he packet. cherisim@putor ~]$ traceroute -g [IP address] google.com Traceroute command is a network diagnostic tool for displaying the route packets take to network host or destination. 30 hops max, 60 byte packets 1 192.168.2.1
Jul 02, 2020 · 5-30ms response times are considered a good high-speed hop response time. Most commonly, you’ll see times between 35-60ms. When you begin to see times of 60ms+, that may be indicative of a delay. Column 5 (hostname or IP address) – This item returned by the router in the path.
Traceroute "gives up" after a certain number of hops. This done by limiting the maximum TTL in the packets which, by default on Linux, is 30. You can change this with the -m option. There may be more or fewer hops but since none of them after the 6th one are responding, we just don't know. If the issue is that traceroute goes more than 30 hops to reach the destination and does not complete, then the best solution is to use extended trace (from privilege mode) and set the maximum number of hops to a larger value like this: Oct 16, 2017 · Prevents tracert from attempting to resolve the IP addresses of intermediate routers to their names. This can speed up the display of tracert results. /h